The file client.dll could not be setup properly

[Sarahevo]

Hi to all!

As the subject says .... please, see the attachment.

A picture is worth a thousand words.

Thanks in advance.

Sincerely,

[rajkosto]

Hi you
as the forum has contents, that you can search
resolution of this problem is done
by installing the microsoft visual c++ 2010 sp1 runtimes
available here http://www.microsoft.com/en-us/download/...px?id=8328
(in fact, the thread right below this one, describes the same problem)
(could you not have bothered to at least read it ?)

[Sarahevo]

Hi again Thou,

This is not the solution for me.

I had readed that post and realized that I had installed these components yesterday, before post this issue. However, I reinstalled and I still have the same problem ... ¬

Thanks.

(31-01-2013, 11:02 PM)rajkosto Wrote: Hi you
as the forum has contents, that you can search
resolution of this problem is done
by installing the microsoft visual c++ 2010 sp1 runtimes
available here http://www.microsoft.com/en-us/download/...px?id=8328
(in fact, the thread right below this one, describes the same problem)
(could you not have bothered to at least read it ?)

[rajkosto]

attach dxdiag

[Sarahevo]

Attaching from the client directory...

Maybe you need some specific section of DxDiag? It is in the other file.

Thanks in advance,

(01-02-2013, 05:06 PM)rajkosto Wrote: attach dxdiag

[rajkosto]

You can't run mxo on that "graphics card"
you can try making an empty text file called rd3d_disable in the matrix client directory
doubt it would help, though

[Sarahevo]

rd3d disable did not help.

Sorry to listen this...

(01-02-2013, 06:22 PM)rajkosto Wrote: You can't run mxo on that "graphics card"
you can try making an empty text file called rd3d_disable in the matrix client directory
doubt it would help, though